Connectors & Parts

Chassis for Modulus-86 Rev. 3.0, Modulus-186, and Modulus-286. All mounting hardware needed to assemble the chassis and attach the circuit boards w...

Output inductor for use with: Modulus-86 Rev. 2.3 and above (requires one inductor) LM3886 Done Right (requires one inductor) Specifications Pi...

5-way binding post featuring: Gold plated. Accepts bare wire up to AWG 8 (8 mm2). Compatible with 4 mm banana plugs and spade terminals. Rotating ...

Keratherm Red (86/82) is a thermal interface material with an extremely low thermal resistance. Thus, it is ideal for thermal pads in high-power ap...

Wiring harness for the Modulus-686 power amplifier. This harness includes: Input connector (Amphenol TJ0331530000G) Power supply connector (JST VL...

Chassis for a stereo Purifi 1ET400A or Hypex NC500 Class D power amp powered by a Hypex SMPS1200A400 power supply. The chassis further supports the...

The Voltage Regulator allows for the use of the Hypex HPR and HNR voltage regulators with the Input Buffer. In addition, it allows for the use of t...

This wiring harness is intended for use with the Purifi 1ET400A / Hypex NC500 Input Buffer. The Input Buffer offers support for the use of external...

The Purifi/Hypex SMPS Splitter allows you to connect up to three Purifi 1ET400A or Hypex NC500 to one Hypex SMPS1200 power supply.  The SMPS Splitt...

Unlike other PCB mounted RCA connectors, these high-end connectors use round pins. This greatly simplifies the PCB layout and results in a much bet...