Neurochrome

The Differential Volume Control PCB is intended for use with a 4-gang ALPS RK271-series, "Blue Velvet" volume pot to form a fully differential (bal...

5-way binding post featuring: Gold plated. Accepts bare wire up to AWG 8 (8 mm2). Compatible with 4 mm banana plugs and spade terminals. Rotating ...

The Neurochrome HP-LOAD is a stereo (2-channel) dummy load intended for use in the testing of headphone amplifiers.  The HP-LOAD features: Caddock...

Build a high-performance headphone amplifier for less than $500, including a nice professional chassis! The HP-2 is an all-DIY, low-distortion head...

Build a high-performance headphone amplifier for less than $100! The HP-22 is an all-DIY, low-distortion headphone amplifier. It provides 200 mW in...

The Input Selector is a relay-based input selector which supports the selection of one of up to six stereo inputs. It can be used as a passive prea...

Chassis for Modulus-86 Rev. 3.0, Modulus-186, and Modulus-286. All mounting hardware needed to assemble the chassis and attach the circuit boards w...

Wiring harness for the Modulus-686 power amplifier. This harness includes: Input connector (Amphenol TJ0331530000G) Power supply connector (JST VL...

Output inductor for use with: Modulus-86 Rev. 2.3 and above (requires one inductor) LM3886 Done Right (requires one inductor) Specifications Pi...

This input buffer is intended for use with the Purifi 1ET400A and Hypex NC500 Class D amplifier modules. Unlike other buffers, including the Purifi...

Chassis for a stereo Purifi 1ET400A or Hypex NC500 Class D power amp powered by a Hypex SMPS1200A400 power supply. The chassis further supports the...

The Purifi/Hypex SMPS Splitter allows you to connect up to three Purifi 1ET400A or Hypex NC500 to one Hypex SMPS1200 power supply.  The SMPS Splitt...

Unlike other PCB mounted RCA connectors, these high-end connectors use round pins. This greatly simplifies the PCB layout and results in a much bet...

The Selector Switch & Volume Control is a two-part circuit board intended for use with the Input Selector. It is sold as a panel and consists o...

Modulus-286 with Power-686, Guardian-86, Intelligent Soft Start.

Modulus-286 with Connex SMPS300REh and Intelligent Soft Start

The Universal Buffer is a two-channel (stereo) buffer, which can be configured to provide any of the following functions: Single-ended (unbalanced...

The Voltage Regulator allows for the use of the Hypex HPR and HNR voltage regulators with the Input Buffer. In addition, it allows for the use of t...

This wiring harness is intended for use with the Purifi 1ET400A / Hypex NC500 Input Buffer. The Input Buffer offers support for the use of external...